A weblog focused on interesting circuits, ideas, schematics and other information about microelectronics and microcontrollers.
Disclaimer
Because I have not tested all electronic circuits mentioned on this pages, I cannot attest to their accuracy; therefore, I do not provide a warranty of any kind and cannot be held responsible in any manner.
Bus Pirate v3 - prototype
28. November 2009 - 18:50 — admin
The ‘Bus Pirate’ is a universal bus interface that talks to most chips from a PC serial terminal, eliminating a ton of early prototyping effort when working with new or unknown chips. Many serial protocols are supported at 0-5.5volts, more can be added.
(Source: Dangerous Prototypes)
I'm pretty sure you know the Bus Pirate - or you already heard about it. Here is the third version (or "revision") of this amazing hardware: Prototype Bus Pirate v3 - with full history and verbose instructions.
Features:
* Talk to 1-wire, I2C, UART (async serial), SPI, JTAG, MIDI, LCDs, PC keyboards, and a ton of generic serial devices from a terminal.
* Scriptable from Python, Perl, etc.
* 0-40MHz frequency counter, 0-4MHz pulse-width modulator.
* 0-6volt measurement probe.
* 3.3volt and 5volt power supplies with reset.
* On-board pull-up resistors for multi-voltage interfacing.
* Address scanners, chip dumpers, and other helpful macros.
* USB interface, power. USB firmware updates.
* Translations (currently Spanish and Italian, add your own).
You can preorder the Bus Pirate v3 for US$30 - it's pretty cheap for such a device, isn't it?
Comments
Post new comment