A weblog focused on interesting circuits, ideas, schematics and other information about microelectronics and microcontrollers.
Disclaimer
Because I have not tested all electronic circuits mentioned on this pages, I cannot attest to their accuracy; therefore, I do not provide a warranty of any kind and cannot be held responsible in any manner.
Breadboard dual power supply
31. March 2009 - 17:52 — admin
Dual power supply (5V + 3.3V) for your breadboard, based on Linear Technology's LT1529 low dropout regulators.
If you are experimenting with the modern ICs, you have to use not only 5V, but 3.3V too - more and more microcontrollers or circuits needs 3.3V supply (although some are 5V tolerant). Here is a simple tool which helps you to power up your breadboarded circuits by 3.3V and 5V at one time.
It's not original, I confess - the original idea is stolen - ehm, borrowed - from uController.com pages. I'd like to build my own piece, but I haven't suitable 7805-like voltage regulators. Fortunatelly I've found two spare LT1592s, so I've slightly modified the schematics, and voila... :)
If you want to build your own supply, you may use my sources - schematics, Gerbers or ready-to-made PCB design on BatchPCB. Enjoy!
PS: You can omit the diode D1 - LT1529 has a built-in protection diode.
Schematics (Eagle 5 version, with modified linear-technology.lbr file)
BatchPCB ready-to-made design: Dual power supply
Comments
I found this post as I was
I found this post as I was looking for information on how i can combine my homemade solar panels and homemade windmill generator to my home. Not sure if you have any idea?
I would like to have them both connected together rather than buying two seperate battery banks.
If you or anyone else can help please drop me a line on my home page. (click my name).
Thanks
Post new comment