A weblog focused on interesting circuits, ideas, schematics and other information about microelectronics and microcontrollers.
Disclaimer
Because I have not tested all electronic circuits mentioned on this pages, I cannot attest to their accuracy; therefore, I do not provide a warranty of any kind and cannot be held responsible in any manner.
The Beginners Basics: How to identify Electronic Components
15. July 2007 - 14:21 — admin
Have a look at the article Identifying Electronic Components 
on the uCHobby.com . There is almost complete guide to identifying components found on older PCBs or discarded electronics you can recycle and use.
Comments
I have seen guys heat the
I have seen guys heat the back side of a circuit board with a propane torch and bangit on a table to get non crimped parts to fall out. some parts have the wires crimped by the automatic insertion tools thenyou have to unsolder and carefully lift with tweezers as you heat the connection.
Post new comment